NTWMaster

Yes. From zemas and since they have posted, I have not seen anyone share anything. They asked for help in return and I have yet to see it. I've also posted helpful information, like videos (I removed the videos), for questions I've specifically seen and people just react to get it. There doesn't seem to be give and take here like it appears there was in the past. Even the smallest piece of information could hlep others, but no. Just reacts. Zemas shared THEIR information, which I am thankful for, but if the "community" is only going to just take, I will personally share with those who are actually trying to help others. You sound entitled.

.

I attempted to message you, but my account will not allow it. I know it isn't much, but I have one more question to add because I have sat the lab. It is one of those select all that apply. I would post it here, but it seems so many are only interested in getting the information and not supplying it. Again, it is just question but every question helps, right?

For those of you who have had to retake the lab, have you found that the retake lab is always different than the first one? If there are differences, are there completely different scenarios or the same ones with small changes in the task requirements? For both Design and DOO. Thanks

.

Okay, I found one more document that may be helpful. I will obviously know more once I finally take the lab OR someone could be kind enough to say this may be a solution.

I found this on the cisco website. I have not yet taken the lab but maybe this will help with the Tacacs part? Radius is the default when configuring ISE in DNAC. You can't use Tacacs in the Design module if you have not selected it when integrating ISE and

Does anyone have an updated WB they wouldn't mind sharing? The WB I have doesn't mention anything about primary/secondary paths for question 1.4. I can assume what I have isn't the latest, then. Below is what I have. SECTION 1.4: OSPFv2 between HQ and DC (3 Points) For Complete and correct the OSPF configuration on the switches sw101, sw102, sw201 and sw202 according to these requirements: 1. Enable OSPFv2 on the redundant interconnections between the DC and HQ sites. Make sure that OSPF establishes adjacencies on these interconnections and exchange routing information between the DC and HQ sites 2. Protect the authencity and integrity of the OSPFv2 sessions on the redundant interconnections between DC and HQ with the SHA-384 mechanism. Use key ID 1 and a shared secret of “cci3” (without quotes 3. Improve the detection of unreachable OSPFv2 neighbors on the redundant interconnections between DC and HQ so that OSPF can detect the loss of a neighbor within 300 msec, with the probes being sent every 100 msec. It is not allowed to modify OSPF timers to accomplish these requirements. Thanks