x0dia

Hello, has anyone recently taken the ENARSI 300-410 certification? Any valid question banks/dumps. Thank you everyone.

A comment about Q20, Chapter 5. The answer is probably correct. However we are assuming that the "new" router has preemption enabled. About answer C. This is only the delay that the router waits before it preempts. It would try to become active after 10 sec (hold time). --> Therefore this answer is incorrect.

Q.6 Chapter 63 This question is ambiguous. If you do some research you will find out that Salt (Saltstack) can run in agent or agent less mode. However I would still go with the SaltStack --> Agent based option [Hidden Content]

Chapter 35, Q12. I think it should be C, D as Wifi 6E doesn't support WPA2.

Chapter 31, Q 11. Should be Answer B. From ExamTopics with a good explanation: [Hidden Content] [Hidden Content] "When the HA pair is set up, by default, the Primary WLC's MAC address is synced as the Mobility MAC address on the Standby WLC" -> Devices in 5520 HA cluster already have the mobility mac. [Hidden Content] "Ensure that you configure the mobility MAC address using the wireless mobility mac-address command for High-Availability to work" -> Mobility MAC needs to be set manually on new Catalyst 9800.

Chapter 19, Q:18 Explanation for question: BGP RIB failure from ‘show ip bgp’ indicates that a route learned from a neighbor where a lower administrative distance (from a static, or other IGP) has already been installed into the routing table, thus the BGP route has failed to install into the IP routing table (RIB) because it has been trumped by the lower admin distance route.

Chapter 25, Q2: I am pretty sure that the answer is A and B. A because of this: Source: [Hidden Content] There might be some confusion because EIGRP only supports 4 equal cost paths by default. You can increase this up to 16 with the command maximum-path... And B, because this is a fact. It needs to be a feasible successor.

Chapter 22, Q.15 I would say its B. [Hidden Content] is a type of,natively on the host hardware.

Does anyone know how to convert PDFs into markdown files? Please DM me. I think pandoc can only to md to pdf.

Regarding Q.4 Chapter 18. Looking at this output it confirms that Po1 is configured as a trunk.

Regarding Q.5 from Chapter 17. I tend more towards answer C. If we look at this link here. We can see the picture. We see that the output on SW1 is empty. Hence no ports are assigned.

Good explanation for Q.8 Chapter 16. Found on another side. Cross referencing it here

Good explanation for Q.7 Chapter16.

Regarding question Chapter 5, Q3. I think this document gives us the definite answer: [Hidden Content] - I guess they assume the default configuration without specifying a virtual MAC address. Therefore I think A is the correct answer. ------ Chapter 7, Q13 I think the answer should be: A, D From this source: [Hidden Content]