DNAC Home Lab

[Myccie]

Hello Folks,

I am trying to install DNAC 1.3.x.x on Dell PowerEdge R820. I have enough resources and the installation goes without any error, however when the installation completes I am not able to login to the DNAC GUI also not able to issue "maglev package status".

Any idea on why it is nor working or anyone else faced the same issue?

My Server Resources:

CPU: 4X12 2.4GZ

RAM: 767

SSD: 4TB

 

[Myccie]

I tried both admin/maglev credentials, but non of them worked. the CPU is v2.

Edited May 21, 2023 by Myccie

[netkillui]

leave it running for few hours

[freebsd321]

DNAC is not supported in virtualization. Use a hardware appliance. It requires a lot of hardware resources.

This is the hidden content, please

• Sign In
• or
• Sign Up

[masterjack]

6 hours ago, Myccie said:

Hello Folks,

I am trying to install DNAC 1.3.x.x on Dell PowerEdge R820. I have enough resources and the installation goes without any error, however when the installation completes I am not able to login to the DNAC GUI also not able to issue "maglev package status".

Any idea on why it is nor working or anyone else faced the same issue?

My Server Resources:

CPU: 4X12 2.4GZ

RAM: 767

SSD: 4TB

 

 

VM template is incorrect . must use 3 vHDD . per following :

 

 

Watch this : I tried before and its was working : 

 

Edited May 22, 2023 by masterjack

[Myccie]

I have the same number of the disk too. Check the screenshot I provided in my initial post.

[masterjack]

1. Try to set vCPU to 44 Core

2. calculate the ISO file MD5/SHA checksome and compare with Cisco listed checksome ( to make sure iso file is not corrupted).

[Myccie]

I did all of these. The only thing I am not sure of is the RAID configuration. On my server, I tried it with RAID0, RAID1 and RAID5, and I am not sure if it requires any specific type of RAID configuration.

[masterjack]

follow this forum . (working instruction) :https://www.certcommunity.org/forum/topic/866-offer-dnac-sw-1337/?do=findComment&comment=3634

[certway4life]

On 5/22/2023 at 3:04 PM, Myccie said:

I did all of these. The only thing I am not sure of is the RAID configuration. On my server, I tried it with RAID0, RAID1 and RAID5, and I am not sure if it requires any specific type of RAID configuration.

Use RAID 0 and make sure SSD I/O check output is high/passes

[lion2021]

...

[ayodejad]

thx

[surajatmega]

Thanks

[SkyCCIE]

Thanks

 

[ipk]

bru

[passedpassed]

On 5/22/2023 at 4:23 AM, freebsd321 said:

DNAC is not supported in virtualization. Use a hardware appliance. It requires a lot of hardware resources.

Hidden Content

• Give reaction or reply to this topic to see the hidden content.

 

Thanks